and you are powering your box?
I am using this clamp suggested by Michael_Carpenter here along with this UART I found on amazon.
I power the box using the included battery, fully charged, as the clamp unfortunately blocks the power connector.
Wha aren’t you doing the recommended way? (The video is not working)
Can you post a picture of your setup?
Are you using j103 to connect the uart?
I’m not sure what I’m doing wrong.
Sure, here it is.
Yes, that’s where it is connected to.
Just a reminder, but I’m able to get terminal output from the device using a serial console such as the screen command.
I can try sending a video of me trying to dump the certificates if you think it would be helpful.
Quick note: I forgot to add the jumper in that image, but every time I have tried reading the certificates, I have used the jumper before powering the box.
you can, but i am away from keyboard for a while now
Had to use the \ because the video wasn’t embedding properly for some reason.
Can you click on “not secure” right besides the url?
and then website settings?
Is USB-Devices and Serial Interfaces not set to be blocked?
Normally as soon as you click on read there should be a dialog be opened where you can select the port (even if nothing is connected!)
USB-Devices and Serial Interfaces are both set to Ask (Default)
You can’t see it in the video for some reason, probably privacy settings, but it did pop up asking which device to set. I made sure to set it to the correct COM port.
Also, happy new years!
No other tool is open in parallel?
Just my browser, a few messaging programs and steam. Nothing that I think would interfere with the serial connection.
Then I am out of ideas. Please try the legacy approach
I have multiple times, and it times out as well. I’m not sure what’s going wrong, I can get serial output using a serial terminal just fine.
J100 is shortened?
Yes, every time. Has anyone used the UART that I am using before?
Can you post a detailed image of it (including the wires)
Sure, one moment.